End mill holder Weldon BT 50 - 06 - 200Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance1

Hardening depth 0

In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

(without toolholders and inserts)

shank form UF

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

cross head retaining screw and cylinder head retaining screw for cutters with central coolant

The tapered tool holder is thus optimally

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance4

With ball bearing clamping nut

With retaining screw

20 mm only with reduction sleeve)