End mill holder Weldon HSK 100 - 14 - 160Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

wrench and collets

Surface hardened HRC 58~60

For internal machining with boring bars

With drivers

E2= 20 pieces

All holders are made of forged steel

better chip evacuation

Completely made of steel

For the storage of collet chuck

is prevented from attaching itself by vacuum

clamping depth

A possible increase of axial force during the tapping process is reduced to a minimum